Installation guide

The pinion guard is
easily removed and
rotated allowing the rack
to be fitted above or
below the pinion.
8B.5. Use the orange height-
adjustment nuts
provided to level the
gearbox.
8B.6. Tighten the hold-down
nuts when the gearbox is
in the correct position.
Stud
locknut
(M10 half-height nut)
Orange
height-
adjustment
nuts
Washer
Hold-
down
nuts
(M10
nuts)
8B.8. Battery is fitted between
the motor enclosure
unit and the D2 Turbo
Low-Voltage controller.
8B.9. Unclip the orange clips
holding the controller
onto the motor enclosure
unit.
8B.10. Fit the 7Ah/5Ah battery
and clip the orange clips
down to secure the
battery in place.
Theft-resistant
Nut and Discus
padlock are
available from
Centurion System
for sites requiring
additional
security.
Discus
padlock
Theft-
resistant
Nut
Unclip
orange
battery
clip
Clip
orange
battery
clip to
secure
Fit the
7Ah/5Ah
battery
Greater than 500mm
C: Isometric view
Take care with the
orientation of the arrow
on the origin marker.
This arrow must face the
operator.
8B.7. Mount gate origin
marker to rack as per
illustration C, D and E,
with the gate in the
closed position.
Origin
marker
TurboTurbo
10-17mm
Gate
Rack
Origin sensor
inside motor
enclosure
Gate in
closed
position
TurboTurbo
Origin marker
Greater than 500mm
D: Plan view
E: Plan view