Supplementary Document

Page 1 of 3

CertainTeed Ceilings

Trim Edge/Reveal Edge/ Narrow Reveal Edge Installation

Instructions

Components:

1. Trim Edge/Reveal Edge/Narrow Reveal Edge Panel

2. CertainTeed 15/16” Classic Main Runners (for Trim /Reveal Edge)

(or CertainTeed 9/16” Elite Narrow Main Runners for Narrow Reveal)

3. 15/16” Classic Cross Tees

(or 9/16” Elite Narrow Cross tees)

4. CertainTeed Ceilings 15/16” or 9/16” Wall Angle

or Shadow Molding

5. 12 Gauge Hanger Wire

Wear clean white cotton gloves when handling panels.

PAGE 1
CertainTeed Ceilings Trim Edge/Reveal Edge/ Narrow Reveal Edge Installation Instructions 2 5 3 3 4 4 1 Components: 1. Trim Edge/Reveal Edge/Narrow Reveal Edge Panel 2. CertainTeed 15/16” Classic Main Runners (for Trim /Reveal Edge) (or CertainTeed 9/16” Elite Narrow Main Runners for Narrow Reveal) 3. 15/16” Classic Cross Tees (or 9/16” Elite Narrow Cross tees) 4. CertainTeed Ceilings 15/16” or 9/16” Wall Angle or Shadow Molding 5.
PAGE 2
Pre-Installation: Please read CertainTeed Ceiling’s Pre-Installation Instructions before you begin these installation instructions. 1. Installing Wall Molding • To install Wall Molding, choose a height at least three inches below joists, existing ceilings, ducts, pipes, or wiring, to ensure clearance and maneuverability required to install the panels. • Mark the desired height for the finished surface of the ceiling on all four walls. • Attach Wall Molding using appropriate fasteners. 2.
PAGE 3
6. Install Panels • Put on white cotton gloves, so that the dirt and oil from your hands, does not get on the panels. (If gloves become soiled, replace them immediately. • Start installing panels in the middle of the field. • Maneuver and tilt the panels above the grid, then carefully rest the panels on the grid. 7. Install Border Panels • Cut border panels by measuring each one individually. Use a straight edge to make cuts. If you are using Trim Edge panels, simply cut them.