User's Manual

Remote Control System
2008 Cervis, Inc.
7
3.0 Base Unit Installation
CAUTION
Make sure the machine on which the base unit is to be attached is
disabled during installation.
Use the configuration diagrams supplied by Cervis to guide you in mounting the base
unit and connecting your wiring harness. Mounting of the base unit is left much to your
discretion with the following guidelines:
• Make sure that the configuration diagrams supplied with the system are available.
Keep them where they can be easily accessed when needed.
• Make sure the wiring harness is at hand.
• Mount the receiver away from any intense radio or electric disturbance sources.
• Mount the unit where you have enough room for your wiring harness connections.
• Make sure the mount is secure.
Figure 7. Base Unit
102mm (4”) center-to-center
7.4mm (0.29”) dia.
Mounting Holes
Cable Connector