User's Manual
Table Of Contents
SmaRT 206
U024.2-SmaRT_206_SYS-R
ii
Cervis Inc. Safety Precautions
Read and follow all instructions.
Failure to abide by Safety Precautions may result in equipment failure,
loss of authority to operate the equipment, and personal injury.
Use and maintain proper wiring. Follow equipment manufacturer
instructions. Improper, loose, and frayed wiring can cause system
failure, equipment damage, and intermittent operation.
Changes or modifications made to equipment not expressly approved
by the manufacturer will void the warranty.
Owner/operators of the equipment must abide by all applicable Federal,
State, and Local laws concerning installation and operation of the
equipment. Failure to comply could result in penalties and could void
user authority to operate the equipment.
Make sure that the machinery and surrounding area is clear before
operating. Do not activate the remote control system until certain that it
is safe to do so.
Turn off the handheld remote and remove power from the base unit
before attempting any maintenance. This will prevent accidental
operation of the controlled machinery.
Use a damp cloth to keep units clean. Remove mud, concrete, dirt, etc.
after use to prevent obstructing or clogging the buttons, levers, wiring,
and switches.
Do not allow liquid to enter the handheld or base unit enclosures. Do
not use high pressure equipment to clean the handheld remote or base
unit.
Disconnect the radio base unit before welding on the machine. Failure
to disconnect the base unit may result in destruction of or damage to
the base unit.
Operate and store units only within the specified operation and storage
temperatures defined in 6.0 Specifications of this document.