User's Manual

4
Installation
Installation Prerequisites
OVERVIEW
JuiceBox requires either a hardwired electrical connection or a NEMA 14-50 outlet.
The JuiceBox power supply must be connected to a non-GFI circuit breaker that is rated for
at least 125% of the device's continuous load.
NOTE
Ensure that all power connection wiring conforms to the rules and regulations of any
national and local codes.
> The JuiceBox may require a disconnecting means if:
> Not within line of sight of the Electrical Panel
> Required by local code
> Hardwire Version: Only the pre-installed, hard wire whip shall be used to connect to a
junction box or disconnect. It is not long enough, nor is it meant to go directly into the
electrical panel.
CAUTION
Do NOT drill any additional holes into the JuiceBox enclosure as it can cause damage
to the PCB and/or electronics inside.
LOCATION
When selecting a location to install the hardwire connection or outlet, keep in mind that
JuiceBox should be positioned:
> Within reach of the vehicle's charge po
> 18 inches above the oor or ground
> If applicable, within range of a cellular connection or the local WiFi network