User Manual

counted are placed on the weighing pan, and then the "PCS count" key is
pressed. The display changes to "---" wait state, and the display changes
later. The averaging operation is done for “10”, and the balance can
perform the counting operation.(In this operation, the zero point must be:
“0 or 0.0 or 0.00”, the weight of a single count must be greater than the
balance minimum readable, ie resolution)
6. Balance Unit Conversion Operation
Press “UNIT” unit conversion key. Each press can be displayed in turn,
“CT (carat)”, “OZ (ounce)”, “LB” (pound), g, or Kg “(grams or
kilograms), according to Users need to display different weighing units.
The default value of the balance boot is "g" (grams).
7. Overweight Alarm
When the mass of the object is said to exceed (1+2%) of the value
displayed on the display, the horizontal "---" sign indicates that the
accumulative item exceeds the specified range, and the scale should be
removed immediately, otherwise it will damage the balance.
8. Attention
(1) Before using it should be energized preheating.
(2) The tare weight and the weight of the object must not exceed the
weighing range.
(3) If the weighing is not accurate, use standard weights to calibrate the
balance.
(4) To remove the weighing pan from the balance, turn the weighing pan
clockwise and remove it. Do not push the weighing pan upwards to
avoid damaging the sensor.
(5) If there is an error message, please check the table.
Error message
Reason
Treatment
underline —
The weight on the
Recalibrate with weights
balance is negative
Upper horizontal line
Overweight alarm, see
Recalibrate with weights
—
Article 10
ERR-1
Continuous switch
Shut down for 3 seconds
caused
before booting
ERR-2
Weighing is not stable
Wait a moment
口
Low battery voltage
Change the battery
9. Product standard
Product standard: Electronic GBT 26497-2001
CGOLDENWALL® HZ Electronic balance
Brand Store: https://www.amazon.com/stores/node/16348280011