Installation guide

12
SCON-3074 Configuration
707112-001
Media Type
Through the media type option, you can allow the SCON-3074 to auto negotiate the link
speed between 100 Mbps and 10 Mbps. You can also predefine the connection to either value.
Duplex Mode
You can define whether the FET card is to run in full duplex mode or auto detect whether it
is to run in full duplex or half duplex mode.
TCP/IP
This toggle field must be enabled to configure any connections or circuits to this card.
Options are: DISABLE or ENABLE.
Line Options, TCP/IP Options Panel
Line Options/FET1 LINCS C8.2 Central Control
TCP/IP OPTIONS
IP Address: 195 195 195 001
Subnet Mask: 255 255 255 000
TN3270 Client Connections: 0000
BSD 4.2 IP Broadcast: Disable
Expanded IP Addressing: Disable
TCP Quiet Time (sec): 0000
Default Router Address: ___ ___ ___ ___
DNS Primary Name Server: ___ ___ ___ ___
DNS Secondary Name Server: ___ ___ ___ ___
DNS/Ping Response Time: 0000
DNS Default Domain: _______________________________________
SNMP Trap IP Address: ___ ___ ___ ___
SNMP Read Authentication String: _____________________
SNMP Write Authentication String: _____________________
PF: 1-Menu 7-Back 8-Forw 9-Default 10-Done
When TCP/IP is enabled as the protocol for the FET (Ethernet) board, the Line Options,
TCP/IP Options panel will appear. The minimum configuration for this panel requires that
you fill in an IP address and the number of TN3270 clients you wish to support through it. In
most cases however, you will also need to fill in the Default Router address, and you may also
want to fill in the Subnet Mask field. Below you will find descriptions for all of the options on
this panel.
IP Address
This is the IP address for the line. It should follow the rules for IP addresses, which your
system administrator can give you. If this address is connected to the Internet as controlled by
the NIC, bear in mind that users can connect to LINCS by the IP address you give it. Design
your host’s connection to the Internet with this in mind.