User's Manual

5
1. Check the converyor drive motor to ensure it rotates in the correct direction. The motor
shaft must rotate in a counterclockwise direction when viewed from the rear.
2. The dishwasher motors are pased together; therefore, if the conveyor motor rotation is
correct then the pumo motors will also be correct.
3. If the conveyor motor rotation is not correct, then reverse the L1 and L2 wires on the
out put side of the dishwasher main ternimal block located inside the top-mounted
control cabinet. Check to ensure the conveyor motor rotates counterclockwise after
reversing the wires.
NOTE:
The prewash, wash and rinse pump motor shafts rotate clockwise when viewed from the
rear. In addition, the motors have direction arrow labels indicating the properrotations.
Installation
Electrical Connections (continued)
Motor Rotation
THREE PHASE
POWER CONNECTION
LINE IN
L1 L2 L3
GRD
Main Terminal Block Inside the Top-mounted Control
Cabinet.
Motor Direction Rotation Label on Motor Frame.
WARNING:
Moving Conveyor Parts may cause INJURY OR DEATH.
Keep hands and clothing clear of the conveyor when the
conveyor is moving.
USE EXTREME CAUTION WHEN THE CONVEYOR
IS MOVING.