Instruction manual

1. Press until the main screen appears.
2. Press
and the hour digits start blinking. Set the current hour with the aid of
and .
(Note the AM or PM designation)
3. Press
and the minute digits start blinking. Set the current minute with the
aid of
and .
* For 24-hour clock display (military time): Once the hour/minute digits are not
blinking or stop blinking, press concurrently
and and the time will switch
from AM/PM to military time. Pressing these buttons simultaneously again will
revert the display back to AM/PM hour display.
Setting the Current Day of the Week
After the current time has been entered set the
days of the week to irrigate.
1. Press
until a blinking appears at the top
of the display.
2. Set the water droplet
on the current day of
the week by pressing
or . Press
to review
8.3 PROGRAMMING A WEEKLY IRRIGATION SCHEDULE (Specific days of
the week)
This section illustrates an example of weekly irrigation programming. Simply
alter the data in the example and change the program to meet your irrigation
requirements. Let’s assume that we want to program the irrigation controller to
water three times a day at 8:00 AM, 1:30 PM and 7:00 PM for 10 minutes each
time on Tuesdays and Fridays, only.
First, program the watering duration
1. Press
until appears opposite the word
DURATION with the hour digits blinking
0:05, which means 5 minutes (It may show
another time if programmed).
2. Per our example, set it to 10 minutes, or
10