Instruction manual

12
the minute digit, which will start blinking. Press
or and set to 30 minutes.
To set the third start time, repeat the steps for START III, setting the start time at
7:00 PM. Up to 4 start times can be programmed by repeating the steps above.
Press
to exit.
3. To cancel one of the start times, select the start time by pressing
until the
desired start time is reached. The hour digit flashes automatically. Press
or
until the word OFF appears, which is between 11:00 PM and 12:00 AM.
8.4 Setting a Cyclical Irrigation Program
This section illustrates an example of cyclical irrigation programming. Alter the data
in the example to meet the requirements of the project being installed. Let’s assume
that we want to program the irrigation controller to open the valve at 10:45 am for a
duration of 1 hour and 30 minutes, once every three days, starting on Monday.
Setting Irrigation Duration
1. Press the main button and
appears opposite the word Duration with the
hour digits blinking 0:05, which mean 5 minutes (It may show another time if
programmed).
2. Per our example set it to 1 hour and 30 minutes, or 1:30. To set the duration for
1 hour and 30 minutes, press
, and select one hour, then press the , and
the minute digits are blinking. Press
or until the minute digits reach 30
minutes.
Setting Irrigation Cycle
1. Press
and the appears opposite the word DAYS with OFF blinking. If any
droplets can be found under any day of the week, press
, and under M
starts flashing. Press
until only is flashing.
2. Press
and appears opposite the
word START with OFF blinking.
Press
, and 3 hours appears, continue
to press the
until the hours change to
days. Select 3 days and press
; START