Instruction manual

5. COLLAR ASSEMBLY
1. Hold the collar by the round shaped sides
(see Figures 1 and 2).
2. Invert the controller assembly and use firm
pressure to insert the lower side of the collar
into the controller’s center nub (see Figure 3).
3. Lower the collar and snap it to the groove at
the lower part of the Controller assembly (see
Figure 4).
4. Insert the controller assembly with the collar
on the to of the solenoid and make sure the
wire fits through the larger slot (see Figure 5).
6
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
IRRIGATION PRODUCTS