Manualshelf

Use and Care Manual

ManualsBrandsChampion Power Equipment ManualsGenerators12,500-Watt Air Cooled Automatic Home Standby Generator with 100 Amp 14 Circuit Transfer Switch
21222324252627282930
22
Model 100136
OPERATION
Part No. 101306 Rev. A
Before operating the generator, review SAFETY section starting
on page 7.
ENCLOSURE AND ACCESS
Open the enclosure to gain access to the generator and its
components. (Figure 10) Unlock the handles. Turn the handles
and lift the hoods up and to the outside.
Figure 10
PRE-START CHECKLIST
To make sure the generator is ready for proper operation, the
following items should be checked:
• Fuel valve is in the ON position
• No fault code LEDs are lit
• Battery is at full charge
• ATS control module is in the AUTO position
• Engine control module is in the ATS position
• Transfer switch lever is in the Utility Power position
TURNING OFF THE GENERATOR
If you need to shut off the generator when it is running, turn
the engine control module switch to the OFF position. This will
shut off the engine. With the engine control module in the OFF
position, the generator will not start, even if there is loss of utility
power.