Use and Care Manual

Model 100136
MAINTENANCE
24
Part No. 101306 Rev. A
NOTICE
DO NOT overll the engine with engine oil. Damage to the
engine may occur.
4. Remove the dipstick. The oil level should be at the FULL
mark. If necessary, add oil. DO NOT overll.
Figure 12
5. Install the dipstick.
6. Turn the engine control module switch to its prior position.
CHANGING THE ENGINE OIL
!
WARNING
Always wear protective glasses
or goggles and protective clothing
when changing hot engine oil.
1. Turn the ATS to the OFF position.
2. Turn the engine control module switch to the MANUAL
position.
3. Allow the engine to run until it reaches operating
temperature.
4. Turn the engine control module switch to the OFF position.
NOTICE
Always be environmentally responsible. Consult the local
authorities or reclamations facility for proper disposal of
engine oil waste.
5. Position drain pan under alternator.
6. Loosen hose clamp on oil drain hose and slide drain hose
off retaining pin. (Figure 13)
1
2
3
Figure 13
1. Oil Drain Hose
2. Hose Clamp
3. Retaining Pin
7. Position drain hose into drain pan and allow crankcase to
empty.
8. With the oil drained, remove oil lter by turning
counterclockwise.
9. Apply a light coat of clean engine oil to the gasket of the
new oil lter.
10. Screw the new oil lter on (turning clockwise) by hand
until the gasket contacts the engine block.
11. Screw the lter an additional 3/4 turn.
12. Reinstall the hose onto the retaining pin and reposition
hose clamp.
13. Fill the engine with the proper amount of engine oil. See
Figure 12.
14. Turn the engine control module switch to its prior position.
15. Turn the ATS to the AUTO position.