Full Product Manual

8
100250 ENGLISH
67
66
38
57
30
3
2
35
ASSEMBLY
Your log splitter requires some assembly.
If you have any questions regarding the assembly of your
log splitter, call our help line at 1-877-338-0999. Please
have your serial number and model number available.
Open Shipping Crate
1. Set the shipping crate on a solid, flat surface
2. Carefully cut the shipping bands and remove lid of
shipping crate.
3. Locate all hardware before beginning assembly.
3) Install the Tow Bar
1. Attach the tow bar (57) to the bracket on top of the
hydraulic oil tank (30) with two M12x85 bolts (35),
M12 washers (3) and M12 lock nuts (2). (A)
2) Install the Wheels
1. Remove the two plastic shipping caps from the wheel
hubs.
2. Slide the wheel (27) onto the axle.
a. Be sure the tire valve stem is facing out.
3. Thread the castle nut (25) on the axle and tighten by
hand. Use a wrench to tighten another ¼ turn.
4. Spin the wheel (27) to distribute the bearing grease.
5. Loosen the castle nut (25) and re-tighten by hand.
6. Install the cotter pin (29) through the axle and castle
nut. (25)
7. Check to be sure the wheel (27) spins freely.
8. Install the axle cap (24) using a soft face mallet or
hammer and wood block.
9. Repeat for the other wheel.
4) Install the Support Leg
1. Insert the support leg (67) into the leg holder on the
tow bar and secure with pin (66) and R-pin (38).
Keep dirt and debris away from the wheel bearings
during assembly.
NOTE
67
66
38
57
30
3
2
35
A
Over-tightening the castle nut will cause the
bearings to run hot and fail prematurely.
CAUTION
27
29
25
24
1) Install the Hydraulic Oil Filter
Install the oil filter base onto the hydraulic oil tank.
The barb fitting should be oriented vertically and once
installed the oil filter should be oriented so that it does
not extend below the hydraulic oil tank.
2) Install the Wheels Cont’d.