Full Product Manual

10
100250 ENGLISH
ASSEMBLY
1. Attach log catcher (23) to side of beam with four
M10x15 bolts (20), M10 lock washers (21), and
M10 washers (22).
2. Repeat step 1 for the other side.
8) Install the Log Catchers
22
20
21
23
7) Install the Engine and Hoses Cont’d.
The pump outlet connection does NOT require teflon
tape. The o-ring seals against the face of the fittings on
the pump and hose. Tighten to approximately 12 ft-lb.
Over-tightening can damage the pump.
NOTE
7) Install the Engine and Hoses
1. Attach the engine/pump to the engine mounting plate
on the hydraulic oil tank. (A) Secure with hardware
provided.
2. Place O-ring into the outlet fitting on the top of the
pump. (A)
3. Connect one end of the high pressure hose to the
pump outlet fitting and the other end to the inlet on
the control valve. (B)
4. Connect one end of the clear oil hose to the hydraulic
oil tank just beneath the engine and the other end to
the pump inlet on the bottom of the pump. (C)
The swivel nut end of the high pressure hose
connects to the pump outlet.
NOTE
C
B
A
5. Connect one end of the oil return hose to the outlet
barb fitting on the control valve and the other end to
the barb fitting on the oil filter. (D)
6. Install the hose retaining ring to the side of the
splitting beam. (E)
E
D