Full Product Manual

100302 - 4000W DIGITAL HYBRID PORTABLE GENERATOR
CONTROLS AND FEATURES
12
-1
Control Panel
1. Engine Switch – Used to put in START mode or STOP the
generator.
2. Economy Mode Switch – Enables/disables automatic idle
control.
3. Ground Terminal – Consult an electrician for local grounding
regulations.
4. Output Indicator Light – Remains ON during normal
operating conditions. Turns OFF when generator is
overloaded.
5. Overload Indicator Light – When ON, generator is
overloaded and power to receptacles is cut.
6. Low Oil Warning Indicator Light – When ON, engine will
shut down and not run. Check oil level.
7. Parallel Outlets – Used to parallel two inverters together for
increased power output. (parallel kit sold separately).
8. Circuit Breakers (Push Reset) – Protects the generator
against electrical overloads.
RECEPTACLES
A
z
12V DC, 8A (Automotive)
May be used to supply electrical power for
operation of 12 Volt DC, 8 Amp electrical loads.
B
t
120V AC, 30A RV (NEMA TT-30R)
May be used to supply electrical power for
operation of 120 Volt AC, 30 Amp, single phase,
60 Hz electrical loads.
C
A
(2×) 120V AC, 20A (NEMA 5-20R)
May be used to supply electrical power for
operation of 120 Volt AC, 20 Amp, single phase,
60 Hz electrical loads.
 WARNING
Do not operate a device while it is plugged into the 12V DC
outlet. Prolonged exposure to engine exhaust can cause
serious injury or death. While charging a device do no place
on the exhaust side of the generator. Extreme heat caused
by exhaust can damage the device, and cause a potential fire
hazard.
1
4
5
7 8
6
2
3
A B
C