Product Brochure

ManualsBrandsChampion Power Equipment ManualsPortable Generators100307

100307 ENGLISH

OPERATION

Connecting Electrical Loads

1. Let the engine stabilize and warm up for a few

minutes after starting

2. Plug in and turn on the desired 120 Volt AC single

phase, 60 Hz electrical loads.

– DO NOT connect 3-phase loads to the generator.

– DO NOT connect 50 Hz loads to the generator.

– DO NOT overload the generator.

If the engine starts but does not run make certain

that the generator is on a ﬂat, level surface. The

engine is equipped with a low oil sensor that will

prevent the engine from running when the oil level

falls below a critical threshold.

NOTE

LPG

1. Make certain the generator is on a ﬂat, level surface.

2. Disconnect all electrical loads from the generator.

Never start or stop the generator with electrical

devices plugged in or turned on.

3. Fully open the LPG cylinder fuel knob.

4. Turn the LPG fuel valve to the “ON” position.

5. Move the choke lever to the “75% Choke” detent

position.

a. For restarting a warm engine, move the choke

lever to the “75% CHOKE” detent position.

6. Press the engine switch to the “ON” position.

7. RECOIL START: Pull the starter cord slowly until

resistance is felt and then pull rapidly.

8. Do not over-choke. As soon as engine starts, gradually

move the choke lever to the “RUN” position over a 2-5

second duration.

For LPG starting in cold ambient < 15°C (59°F)

Move the choke lever to the “100% CHOKE” for

recoil start.

NOTE

Connecting a generator to your electric utility

company’s power lines or to another power source

may be against the law. In addition this action,

if done incorrectly, could damage your generator

and appliances and could cause serious injury or

even death to you or a utility worker who may be

working on nearby power lines. If you plan to run a

portable electric generator during an outage, please

notify your electric utility company immediately

and remember to plug your appliances directly

into the generator. Do not plug the generator into

any electric outlet in your home. Doing so could

create a connection to the utility company power

lines. You are responsible for ensuring that your

generator’s electricity does not feed back into the

electric utility power lines.

If the generator will be connected to a building

electrical system, consult your local utility company

or a qualiﬁed electrician. Connections must isolate

generator power from utility power and must comply

with all applicable laws and codes.

WARNING