Operating Guide

100384 - 3200 PSI PRESSURE WASHER
ASSEMBLY
10
Add Engine Oil
 CAUTION
DO NOT attempt to crank or start the engine before it has
been properly filled with the recommended type and amount
of oil. Damage to the pressure washer as a result of failure
to follow these instructions will void your warranty.

NOTICE
The recommended oil type is 10W-30 automotive oil.
1. Place the pressure washer on a flat level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Add up to 0.6 qt. (0.6 L) (not included) of oil and replace oil
fill cap/dipstick. DO NOT OVERFILL.
4. Check engine oil level daily and add as needed.

NOTICE
Once oil has been added, a visual check should show oil
about 1-2 threads from running out of the fill hole.
If using the dipstick to check oil level, DO NOT screw in the
dipstick while checking.
Full Synthetic 5W-30
Degrees Celsiusº
(Outside)
(Outside)
Degrees Fahrenheitº

NOTICE
We consider the first 5 hours of run time to be the break-
in period for the engine. During the break in period we
recommend using standard automotive non-synthetic
blended oils. After the break in period synthetic lubricant
can be used but is not required. Adjusting throttle setting
will increase/decrease engine speed helping to seat piston
rings. Avoid bogging or lugging the engine down and avoid
prolonged running at constant RPM. After the 5 hour break-
in period, change the oil. Using synthetic lubricants does not
increase the recommended oil change interval.
 CAUTION
The engine is equipped with a low oil shut-off and will stop
when the oil level in the crankcase falls below the threshold
level.

NOTICE
Check oil often during the break-in period. Refer to the
Maintenance section for recommended service intervals.

NOTICE
The engine rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the
bearing.

NOTICE
Weather will affect engine oil and engine performance.
Change the type of engine oil used based on weather
conditions to suit the engine needs.