Operating Guide

100384 - 3200 PSI PRESSURE WASHER

ASSEMBLY

Parts Included

Gun Assembly

Spray Wand (A)......................................................................1

Trigger Gun (B) ......................................................................1

Quick Connect Nozzles (C) ..................................................... 5

Hoses

25 ft. (7.6 m) High Pressure Hose (D) ..................................... 1

4 ft. (1.2 m) Detergent Hose (E) ............................................. 2

Other

Oil Funnel (F) .........................................................................1

ASSEMBLY

Your pressure washer requires some assembly. This unit ships

from our factory without oil. It must be properly serviced

with fuel and oil before operation. If you have any questions

regarding the assembly of your pressure washer, call our help

line at 1-877-338-0999. Please have your serial number and

model number available.

Remove the Pressure Washer from the

Shipping Carton

1. Set the shipping carton on a solid, ﬂat surface.

2. Remove everything from the carton except the pressure

washer.

3. Carefully cut each corner of the box from top to bottom.

Install Handle to Bottom Frame

1. Line up the handle with the bottom frame.

2. Make sure the handle holes are lined up with the bottom

frame spring button (A). Front face of shroud (decal side)

should face the engine

3. Slide the handle downward on the bottom frame, until

the spring buttons have popped through the holes on the

handle frame. A “click” may sound. (B)

4. Gently pull up on the handle to make sure that two frames

have made a solid connection and that the handle can not

be pulled off without pressing on the spring buttons to

release it.