Replacement Part List

11
ENGLISH 100398
ASSEMBLY
Hybrid Mount Polaris
®
Sportsman
®
Install
1. Measure the thickness of your tube frame and skid
plate (if installed), see Figure 23. Then cut the
provided rubber spacers to a
1
⁄4 in. (6.4 mm) longer
then the thickness of the tube frame.
If there is a skid plate installed and you do not wish
to remove it, you will need to mark the locations
where the bolts will be installed and drill holes.
NOTE
Figure 25 - Hybrid Mount Sportsman Install
FRONT
5.4
1
2
5.3
5.2
5.5
4
3
Figure 23 - Frame Measurement
Figure 24 - Fastener Placement
1
2
3
4
FRONT
FRONT
ACCEPTABLE
INCORRECT
RECOMMENDED
FRONT
2. Place the upper mount plate (2) over the frame at
the location behind the tires where the frame widens
out. Refer to Figure 24 for best fastener placement.
3. Determine the location allowing the mount to be
centered, back as far on the frame as possible and
the push tubes to be attached. Keep the mount holes
within the approximate distance (26 in. {66 cm})
from the front of your machine. See page 8,
Figure 16.
4. Loosely install the upper mount plate (2), 4 spacer
plates (3) and lower mount plate (1) using the rubber
spacers (4),
3
⁄8 in. (9.5 mm) bolts (5.4),
3
⁄8 in.
(9.5 mm) carriage bolt (5.5), nuts (5.2) and washers
(5.3) provided with your mount. See Figure 25.
5. Tighten all bolts evenly. Carriage bolt only needs
to be snug to plate as its purpose is to keep both
plates from bending in the center.
Hybrid Mount Polaris
®
Sportsman
®
Install Cont’d.
Ensure that the rubber spacers are tight against the
frame before tightening the bolts. If this is done
incorrectly the mount could move and the plow may
damage your machine.
NOTE