Full Product Manual

100424 - 27 TON FULL BEAM LOG SPLITTER
ASSEMBLY
12
4. Block the wheels to prevent the frame from rolling.
5. Pivot the beam to the horizontal position and secure it with
the lock pin (54) and R-clip (56) through the tow bar.
54
56
! WARNING
The beam is extremely heavy and should only be handled
with 2 or more people. DO NOT try and lift or handle the
beam without assistance.
5) Install the Fenders
1. Attach the fender (35) to the side of the hydraulic oil tank
with an M10 × 25 bolt (36), Ø10 washer (22), Ø10 lock
washer (21) and M10 nut (26). The safety reflector should
be facing the back of the hydraulic oil tank.
2. Repeat with second fender on opposite side.
36
35
22 21
26
6) Install the Engine and Hoses
"
NOTICE
High Pressure Hose
– This is the only hose with steel connectors crimped on
both ends.
– One end connects to the control valve (sealed with
thread seal tape).
– Other end connects to the top of the pump (sealed by
O-Ring).
– Because of the male/female ends, this hose only fits the
correct way.
Suction Hose
– This is the clear hose that connects the hydraulic tank to
the pump inlet.
– Secure both ends of hose with hose clamps.
Oil Return Hose
– This hose returns the oil exiting the cylinder to the tank
– It has no connectors crimped onto it.
– The hose ends push over barbed fittings on the control
valve and the oil filter.
– Secure both ends of hose with hose clamps.
– Notice how the hose is placed through the retainer ring
on the beam. This holds the hose close to the frame so
it does not flop out beyond the wheels (and catch on
things while towing).
! CAUTION
Red shipping plugs must be removed from hydraulic pump
prior to installing hoses.
Hydraulic pump may
contain residual oil from
testing procedures
during production.
We recommend using an
oil tray under the pump
before removing the
shipping plugs.
1. Attach the engine/pump to the engine mounting plate on
the hydraulic oil tank. Secure with hardware provided.
2. Connect hose to control valve first.
3. Place O-ring into the outlet fitting on the pump (A). Then
connect the other end to the pump. Connect one end of the
high pressure hose to the pump outlet fitting and the other
end to the inlet on the control valve (B).