Full Product Manual

100424 - 27 TON FULL BEAM LOG SPLITTER
ASSEMBLY
13
A
B
"
NOTICE
The swivel nut end of the high pressure hose connects to
the pump outlet.
"
NOTICE
The pump outlet connection does NOT require thread seal
tape. The o-ring seals against the face of the fittings on the
pump and hose. Tighten to approximately 12 ft-lb. Over-
tightening can damage the pump.
4. Using the provided d32 hose clamps, connect one end of
the clear oil hose to the hydraulic oil tank just beneath the
engine and the other end to the pump inlet on the side of
the pump (C).
C
5. Using the provided d25 hose clamps, connect the hydraulic
hose to the barb fitting on the control valve. Connect the
other end of the hose to the barb fitting on the oil filter (D).
D
7) Install the Log Catchers
1. Attach large log catcher (23) to side of beam with four
M10 × 15 bolts (20), Ø10 lock washers (21), and Ø10
washers (22).
2320
21
22
2. Attach small log catcher (25) (opposite side from engine) to
the beam with two M10 × 30 bolts (24), Ø10 washers (22),
Ø10 lock washers (21) and M10 nuts (26).
24
25
22
21
26
Add Engine Oil
! CAUTION
DO NOT attempt to crank or start the engine before it has
been properly filled with the recommended type and amount
of oil. Damage to the engine as a result of failure to follow
these instructions will void your warranty.
"
NOTICE
The recommended oil type is 10W-30 automotive oil.
-20 0 20 40 60
Ambient temperature / Temperatura ambiente / Température ambiante
Recommended Oil Type / Tipo de aceite recomendado / Type d’huile recommandé
80 100 120
-28.9
°F
°C -17.8 -6.7 4.4 15.6 26.7 37.8 48.9
10W-30
5W-30 Synthetic / Sintético / Synthétique
10W-405W-30
1. Place the log splitter on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.