Use and Care Manual

100434 - 24 IN. 2-STAGE SNOWBLOWER
MAINTENANCE
28
6. Unscrew the six M6 × 16 bolts (6) of the friction disc
assembly to discard the worn friction wheel rubber ring (7)
and replace with a new one (Fig. 35).
7
6
Figure 35
7. Follow the previous steps in reverse order to reassemble the
parts.
8. Perform a drive test to confirm everything is in working order.
Lubrication
Lubricate the linkage every 10 hours of use and before long-term
storage. Use 0W-30 oil.
No parts inside the gearbox are to be lubricated. All bearings and
bushings are permanently lubricated and require no maintenance.
Lubricating these parts will only result in the grease getting on to
the friction wheel and disc drive plate, which could damage the
rubber clad friction wheel.
Storage
Never store the machine with gasoline in the fuel tank in a
confined area with bad ventilation. Gasoline fumes could reach
open flames, sparks and cigarettes etc.
To avoid the engine freezing and problems starting the engine,
leave the engine running for 5-10 minutes after your work has
been completed. This will ensure all moisture will disappear that
would otherwise cause starting problems.
If the machine is to be stored for a longer period than 30 days, the
following procedures are recommended.
1. Start the engine and let it run until it stops due to lack of fuel.
2. Change the engine oil if it has not been done for 3 months.
3. Remove the spark plug and empty a little engine oil (about 30
mL) in the hole. Crank the engine a couple of times. Replace
the spark plug.
4. Remove the engine safety key.
5. Clean the whole machine thoroughly.
6. Lubricate all the parts as shown in LUBRICATION section
above.
7. Inspect the machine for damage, and repair if necessary.
8. Touch up any paint damage.
9. Apply rust protection to the metal surfaces.
10. Store the machine indoors if possible.
Transporting
If the engine has been running, allow it to cool for at least 15
minutes before loading the machine on the transport vehicle.
A hot engine and exhaust system can burn you and can ignite
some materials.
Keep the engine level when transporting to reduce the possibility
of fuel leakage. Move the fuel valve lever to the OFF position.