Full Product Manual

100519 - 6250W OPEN FRAME INVERTER

ASSEMBLY

Your generator requires some assembly. This unit ships from

our factory without oil. It must be properly serviced with fuel

and oil before operation.

If you have any questions regarding the assembly of your

generator, call our Technical Support Team at 1-877-338-0999.

Please have your serial number and model number available.

Unpacking

1. Set the shipping carton on a solid, ﬂat surface.

2. Remove everything from the carton except the generator.

3. Carefully cut each corner of the box from top to bottom.

Fold each side ﬂat on the ground to provide a surface area

to work with the generator.

Remove Shipping Support Brackets

To protect the generator during shipping, support brackets have

been installed between the engine and frame. These brackets

MUST BE REMOVED BEFORE adding oil or gasoline to the

generator.



NOTICE

DO NOT attempt to run generator without ﬁrst removing the

shipping support brackets. Damage to the generator as a

result of not removing the brackets will void the warranty.

1. BEFORE ﬁlling the engine with oil or gasoline, tip the

generator onto it’s recoil end. Tip onto the ﬂattened

cardboard box the generator came in or other protective

surface so as to not scratch the frame.

2. Remove the bolts from the orange support brackets. Bolts

and brackets can be discarded.

3. Tip the generator upright.

Install the Wheel Kit

 CAUTION

The wheel kit is not intended for over-the-road use.

Install the Wheels

1. Before adding fuel and oil, tip the generator onto it’s end.

2. Slide the roll pin (B) through the wheel (A) from the outside.

3. Slide the roll pin through the mount point on the frame.

4. Secure with the R-clip (C).

5. Repeat to attach the second wheel.

Install the Support Leg

1. Attach the support leg (D) to the generator frame with

ﬂange bolts (E) and ﬂange nuts(H).

2. Slowly tip the generator back down so that it rests on the

wheels and support leg.