Operating Guide

10
100742 - 2 IN. (5 CM) SEMI-TRASH PUMP
IMPORTANT SAFETY INSTRUCTIONS
Operation Symbols
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to more safely operate the product.
Quickstart Label Symbols
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to more safely operate the product.
Starting the Engine
 DANGER
Move water pump outside and far away from windows,
doors and intake ventilation covers.
1. Check oil level. Recommended oil is 10W-30.
2. Check fuel level.
3. Connect inlet and outlet hoses
4. Connect inlet filter
5. Prime the water pump
6. Move the fuel valve to the “ON” position.
7. Move the choke lever to the “CHOKE” position by pulling out.
8. Move throttle to “FAST” position.
9. Press engine switch to “ON” position.
SYMBOL MEANING
Choke. Pull choke knob to “CHOKE”
position.
Run. Push choke knob to “RUN”
position.
Fuel/Gasoline Valve On/Off
Fuel Gauge: Full
Fuel Gauge: Empty
SYMBOL MEANING
On
Stop or Off
Throttle Lever - Fast
Throttle Lever - Slow
10. Pull the starter cord slowly until resistance is felt and then
pull rapidly.
11. As engine warms up, move the choke to “RUN” by pushing in
and adjust the throttle as needed
Stopping
1. Move the fuel valve to the “OFF” position.
2. Press the engine switch to the “OFF” position.
3. Disconnect inlet and outlet hoses for storage.
4. Remove drain plug (bottom) before storage.
2174-L-OP-a
8
1
10W-30

2

6 73 54
1 42 3119 10
K 376 485 152 300 186CG1CG7
ColorsLPN 2174-L-OP
Rev A
Size Spec’d by CPEC
Artwork Notes
3mm corner radius; 2mm safe margin; to be printed
on white substrate.
Revision Changes
---
This ar twork belongs to Champion Power Equipment. The contents are confidential and privileged and shall not be disclosed to or used by or for
outside parties without the explicit consent of Champion Power Equipment.