Operating Guide

18
100742 - 2 IN. (5 CM) SEMI-TRASH PUMP
OPERATION
3. Separate the cam lock coupler and fitting. Align the green
hose to the coupler and mark the locations of the ribs on the
fitting.
4. Mark the second rib on the coupler on the hose.
5. Lay the green hose side by side and place the clamp marked
54-57 in their approximate location.
6. Slide the clamps back and start to assemble the green hose
to cam lock coupler.
7. Insert the threaded or quick coupler in the green rigid suction
hose until properly seated.

NOTICE
You may use a small amount of dish soap on the cam lock
coupler to help ease the green hose on the fitting. Work
the soap around the coupler with your finger. Then work the
green hose on the fitting, by twisting and turning until it’s fully
seated.
8. Slide the clamps marked 54-57 over cam lock coupler just
past the marks you made on the hose earlier.
9. Rotate and align the clamp bolts so you have clearance for
the cam levers to lock in place later.