Operating Guide

5
100742 - 2 IN. (5 CM) SEMI-TRASH PUMP
IMPORTANT SAFETY INSTRUCTIONS
 WARNING
DO NOT immerse the water pump in water.
 DANGER
The water pump develops powerful force.
DO NOT move the water pump when it is in use.
DO NOT use hoses or connectors that are worn, damaged or
frayed.
DO NOT allow children or unqualified persons to operate or
service the water pump.
DO NOT open top plug or drain plug.
 WARNING
Rapid retraction of the starter cord will pull hand and arm
towards the engine faster than you can let go. Unintentional
startup can result in entanglement, traumatic amputation or
laceration. Broken bones, fractures, bruises or sprains could
result.
When starting engine, pull the starter cord slowly until
resistance is felt and then pull rapidly to avoid kickback.
 WARNING
DO NOT pump salt, sludge, sewer, sea, or any other type of
water containing solid material.
 CAUTION
Exceeding the pump specification for total head can damage
the pump and/or hose kits connected to it.
DO NOT modify the pump in any way. DO NOT attempt to
exceed the rated flow. Attempting to increase the rated flow
may damage the unit and/or shorten its life.

NOTICE
DO NOT run the pump dry.
Running the pump dry can destroy the pump seals and will
void the warranty. If the pump was running while dry, stop
the engine and allow it to cool thoroughly before filling the
chamber with water.
 CAUTION
Improper treatment or use of the water pump can damage it,
shorten its life and void your warranty.
Use the water pump only for intended uses.
Operate only on level surfaces.
DO NOT expose water pump to excessive moisture, dust,
or dirt.
DO NOT allow any material to block the cooling slots.
DO NOT use the engine if:
– Equipment sparks, smokes or emits flames
– Equipment vibrates excessively
 WARNING
Use of this water pump can create wet, slippery walking
surfaces.
– Use only on a level surface.
– Make sure there is proper drainage to dissipate water.