Full Product Manual

40065 - WHEEL KIT

ASSEMBLY

 CAUTION

The wheel kit is not intended for over-the-road use.

Install the Wheels

1. Drain oil and fuel, and then tip the generator slowly so that

the engine side is up.

2. Slide the wheel pin roll through the wheel from

the outside. (A)

3. Slide the wheel pin roll through the mount point on the frame.

(B)

4. Secure with the R-Pin. (C)

5. Repeat steps 2-4 to attach the second wheel.

You will need the following tools to install the leg support and

handle:

– 12mm wrench or adjustable wrench (not included)

– Socket wrench with a 12mm socket (not included)

Install the support leg

1. Attach the rubber vibration mounts to the support leg with a

ﬂange bolt M8 x 25 and ﬂange lock nuts.

2. Attach the support leg to the generator frame with ﬂange

bolts M8 x 16 and ﬂange lock nuts and fasten securely. DO

NOT over tighten the lock nuts. (D)

3. Tip the generator slowly so that it rests on the wheels and

support leg.



NOTICE

Some generator models will require removing rubber pads

prior to installing the support leg. The support leg will use the

same holes as the rubber pads.

Install the handle

1. Place the handle over the mounting channel on the frame.

2. Secure the handle to the frame using the two handle bolts.

3. Place a lock nut on the end of each bolt and fasten securely.

DO NOT over tighten the lock nuts. (E)