Owner manual

REV 18890-20140109 12
18890 ENGLISH
MAINTENANCE
The owner/operator is responsible for all periodic
maintenance.
Lubrication
All moving parts within the Electric Hoist having
been Lubricated using high temperature lithium
grease at the factory. No internal lubrication is
required. Lubricate cable assembly periodically
using a light penetrating oil.
Cleaning
Use a damp cloth to clean the exterior surfaces
of the hoist. Use a soft bristle brush to remove
excess dirt and oil. Use an air compressor
(25 PSI) to clear dirt and small debris from the
wire cable spool and other tight places.
Cable Assembly Replacement
It is recommended that any wire cable or spool
modifications be performed by a manufacturer’s
authorized repair facility, and that only
manufacturer-supplied parts be used.
Storage
It is recommended the electric hoist is stored
indoors, in a clean dry place, free from sunlight
and moisture.
1. Make sure the hoist is properly cleaned
before storage.
2. Make sure the wire rope is drawn onto the
spool as much as it can be without damage.
3. Make sure to tie up all cords.
4. Store in a place that moisture can not
damage the hoist.
5. Store in place that excess dust or debris can
not damage the hoist.
Complete all scheduled maintenance in a timely
manner. Correct any issue before operating the
hoist.
Never operate a damaged or defective hoist.
WARNING
Improper maintenance will void your warranty.
WARNING
For service or parts assistance, contact our
help line at 1-877-338-0999
NOTE
DO NOT spray water directly on the hoist or
wire cable. DO NOT wipe the wire cable with
the damp cloth. Use only compressed air to
clean the wire cable.
CAUTION