Owner manual

REV 18890-20140109 6
18890 ENGLISH
ASSEMBLY
Securing the Hoist
This CPE 440 lb./880 lb. electric hoist already
comes with the remote control, power cord, wire
cable and stop bracket attached, and therefore
the user only needs to secure the hoist to a sturdy
support structure using the support brackets
provided.
1. Remove hoist and support brackets from
packaging, being careful to set aside the
mounting hardware needed.
2. Make sure the supporting structure for the
hoist will be secure enough to support the
hoist and any load that may be hoisted.
3. Place the support brackets over the structure.
4. Have a person or two help hold the hoist in
position under the support brackets so the
hoist is aligned with the holes in the support
brackets.
5. Thread the flat washer ø10 and lock washer
ø10 onto the M10x26 bolt.
6. Insert the bolt through the support bracket
and into the mounting hole in the top of the
hoist. Hand tighten bolt.
7. Repeat for the remaining bolts on the two
support brackets.
8. Once all the bolts have been hand tightened
and the hoist is in the desired position,
firmly tighten all bolts using a 16 mm wrench
or socket (not included), until the hoist is
secure.
Assembling the Hoist Cont’d.
Do not attached the hoist to any support
structure that is not firmly secured in a
straight up and down vertical position. The
hoist must remain in a straight up and down
vertical position while in use. Loads should
NOT be hoisted at an angle.
DANGER
The hoist must be secured with both support
brackets (2) and all bolts (4). Do not try and
secure a hoist to any structure with missing or
damaged parts. Secure firmly before use.
CAUTION
Make sure the hoist is secured to a fixed
support structure. It is NOT recommended
to secure the hoist to a moveable support
fixture.
CAUTION
Surge Protection
While there is no way to prevent voltage
fluctuations, electrical equipment may be
protected by making sure your electrical
equipment is connected to a surge protected
outlet or with a rated surge protection device.
Voltage fluctuation may impair the proper
functioning of sensitive electronic equipment.
CAUTION