Owners Manual

ManualsBrandsChampion Power Equipment ManualsGenerators2000-Watt Dual Fuel Portable Inverter Generator with Cold Start Technology, Covered Outlets, CARB Compliant in Black and Yellow

200959 - 2000W DUAL FUEL INVERTER GENERATOR

OPERATION

To prolong the life of your generator and attached devices, follow

these steps to add electrical load:

1. Start the generator with no electrical load attached.

2. Allow the engine to run for several minutes to get up to

temperature.

3. Plug in and turn on the ﬁrst item. It is best to attach the item

with the largest load ﬁrst.

4. Allow the engine to stabilize.

5. Plug in and turn on the next item.

6. Allow the engine to stabilize.

7. Repeat steps 5-6 for each additional item.



NOTICE

Never exceed the speciﬁed capacity when adding loads to the

generator.

Eco (Economy) Mode

The Eco Mode button can be activated to turn on economy control

in order to minimize fuel consumption and noise while operating

the unit during times of reduced electrical output. Eco Mode

allows the engine speed to idle during periods of non-use.

The engine speed returns to normal when an electrical load is

connected. When the economy switch is off, the engine runs at

normal speed continuously.

 CAUTION

For periods of high electrical load or momentary ﬂuctuations,

the Eco Mode should be off.

Parallel Operation

The Champion model 200959 is parallel ready and can be

operated in parallel with another Champion unit to increase

the total available electrical power. A Champion model 100319

parallel kit (sold separately) is required for parallel operation.

For a list of compatible models or to order a parallel kit, please

call customer service at 1-877-338-0999 or visit www.

championpowerequipment.com.

Detailed instructions for parallel kit installation and operation of

the connected generators are provided in the parallel kit operator’s

manual.

Stopping the Engine: Gasoline

1. Turn off and unplug all electrical loads. Never start or stop the

generator with electrical devices plugged in or turned on.

2. Let the generator run at no-load for several minutes to

stabilize internal temperatures of the engine and generator.

3. Turn the fuel vent lever to the “OFF” position.

4. Turn the dial counterclockwise to the “STOP” position.

Important: Always ensure that the dial and fuel vent on the fuel

cap are in the “OFF” position when the generator is not in use.