Owners Manual

201041 - 5000W PORTABLE GENERATOR

ASSEMBLY

Your generator requires some assembly. This unit ships from our

factory without oil. It must be properly serviced with fuel and oil

before operation.

If you have any questions regarding the assembly of your

generator, call our Technical Support Team at 1-877-338-0999.

Please have your serial number and model number available.

Unpacking

1. Set the shipping carton on a solid, ﬂat surface.

2. Remove everything from the carton except the generator.

3. Carefully cut each corner of the box from top to bottom. Fold

each side ﬂat on the ground to provide a surface area to work

with the generator.

Install the Wheel Kit

 CAUTION

The wheel kit is not intended for over-the-road use.

Install the Wheels

1. Before adding fuel and oil, tip the generator on it’s side.

2. Slide the wheel roll pin (B) through the wheel (A) from the

outside.

3. Slide the roll pin through the mount point on the frame.

4. Secure the R-Pin (C).

5. Repeat steps 2-4 to attach the second wheel.

Install the Support Leg

1. Align the Support Foot (H) with the holes on the frame

2. Insert an M8x16 ﬂange bolt (I) through each hole from the

bottom.

3. Secure each bolt with an M8 nut (G) from the top.

Install the Handle

1. Place the Handle inside the mounting channel on the frame.

2. Secure the Handle to the frame using a Roll Pin (E).

3. Place an R-Pin (F) on the end of the Roll Pin and fasten

securely.