Replacement Part List

201158 - 7500W WIRELESS REMOTE START GENERATOR
OPERATION
24
2. Press and hold the ignition switch to the “START” position.
Release as the engine begins to start. If the engine fails to
start within five seconds, release the switch and wait at least
ten seconds before attempting to start the engine again.
 CAUTION
If the ignition switch is held down in the “START” position
longer than 5 seconds it could damage the starter.
Manual Start
1. Disconnect all electrical loads from the generator. Never
start or stop the generator manually with electrical devices
plugged in or turned on.
2. Push the ignition switch to the “ON” position.
3. Move the choke lever to the “CHOKE” position.
3a. For restarting a warm engine, move the choke lever to
75% of the “CHOKE” position.
4. Pull the recoil cord slowly until resistance is felt and then pull
rapidly.
5. Do not over-choke. As soon as engine starts, move the choke
lever to the “RUN” position over a 2-5 second duration.

NOTICE
Keep choke lever in “CHOKE” position for only 1 pull of the
recoil cord. After first pull, move choke lever to “RUN” position
for up to 3 pulls of the recoil cord. Too much choke leads to
spark plug fouling/engine flooding due to lack of incoming air.
This will cause the engine not to start.

NOTICE
For gasoline restarts with hot engine in hot ambient
temperature > 86°F (30°C), keep choke lever in 75% of the
“CHOKE” position for only 1 pull of the recoil cord. After first
pull, move choke lever to “RUN” position for up to 3 pulls of
the recoil cord. Too much choke leads to spark plug fouling/
engine flooding due to lack of incoming air. This will cause the
engine not to start.

NOTICE
For gasoline starting in cold ambient temperature < 59°F
(15°C), the choke lever must be in 100% of “CHOKE” position
for manual start procedures. Do not over-choke. As soon as
engine starts, gradually move the choke lever to the “RUN”
position over a 2-5 second duration.