Replacement Part List

201158 - 7500W WIRELESS REMOTE START GENERATOR
OPERATION
27

NOTICE
Battery power is drawn while the generator is in standby mode
(battery switch ON).
Do not leave generator in standby mode for an extended
period of time or the battery will be completely drained and
the wireless remote and electric start feature will no longer
function.
Manual Stop
1. Turn off and unplug all electrical connected loads. Never start
or stop the generator with electrical devices plugged in or
turned on.
2. Let the generator run at no-load for several minutes to
stabilize internal temperatures of the engine and generator.
3. Press the ignition switch to the “OFF” position.
4. If generator was started electrically, press the battery switch
to the “OFF” position.
5. Turn the fuel valve to the “OFF” position.
Important: Always ensure that the fuel valve, the ignition switch,
and the battery switch are in the “OFF” position when the
generator will not be used for an extended period of time.

NOTICE
If the engine will not be used for a period of two (2) weeks or
longer, please see the Storage section for proper engine and
fuel storage.
Moving the Generator
 CAUTION
– NEVER lift or carry the generator using the folding handle.
– NEVER tilt sideways while moving the generator.
– ALWAYS place the generator on its wheels in the upright
position.
– ALWAYS turn the generator off and ensure the fuel valve is
closed.
– ALWAYS make sure engine and muffler are cooled down
before the generator can be handled safely (typically 15-30
minutes).
 WARNING
The folding handle is not long enough to hold and walk with a
full stride when moving the generator. Always side step as you
walk to avoid injury to your heels and/or feet. Failure to follow
these instructions could result in personal injury or damage to
the generator.
1. Begin by raising the folding handle, found on opposite side of
wheels.
2. Using the handle, tilt the end of the generator slightly off the
ground until balanced on the wheels.
3. While maintaining balance, roll the generator to the desired
location.