Full Product Manual

100624 - 9 TON FULL BEAM LOG SPLITTER

ASSEMBLY

If your log splitter is already assembled, skip the assembly

instructions in this manual.

If unassembled, please read and follow these instructions.

If you have any questions regarding the assembly of your log

splitter, call our Technical Support Team at 1-877-338-0999.

Please have your serial number and model number available.

Open Shipping Crate

1. Set the shipping crate on a solid, ﬂat surface

2. Carefully cut the shipping bands and remove lid of shipping

crate.

3. Locate all hardware before beginning assembly.

Install the Wheels

1. Slide the wheel onto the axle.

2. Install the washer (38) and cotter pin (39) through the axle.

Install the Support Leg

1. Align the Support Leg (28) with the mounting holes under the

beam.

2. Place the M8×25 bolt (24) through the hole.

3. Place a Ø8 Washer (27) and Ø8 Lock Washer (26) on the end

of the bolt.

4. Install the M8 nut (25) on the bolt and tighten. Do not over

tighten.

Install the Beam

1. Align the 4 threaded blocks on the back of the beam over the

4 larger holes on the side of the wheel mount.

2. Thread an M10×20 bolt (34) through a Ø10 Washer (22).

3. Thread the bolt and washer under the wheel mount up into

the small blocks on the back of the beam and tighten.

4. Repeat steps 1-3 for the remaining 3 bolt and washer sets to

complete the mounting of the beam to the wheel mount.



NOTICE

The beam should extend to the opposite side of the wheel

mounts as shown.

 WARNING

The beam is extremely heavy and should only be handled

with 2 or more people. DO NOT try and lift or handle the beam

without assistance.