Full Product Manual

17
100624 - 9 TON FULL BEAM LOG SPLITTER
ASSEMBLY
Install the Hoses
 CAUTION
Red shipping plugs must be removed from hydraulic pump
prior to installing hoses.

NOTICE
Hydraulic pump may contain residual oil from testing
procedures during production. We recommend using an oil tray
under the pump before removing the shipping plugs.

NOTICE
Some hoses may be preassembled by the factory, check your
hoses per below instructions to ensure proper assembly.
Oil Inlet (High Pressure) and Oil Return Hoses
– These hoses are black and have swivel nuts on both ends.
– The oil inlet hose sends hydraulic oil from the pump to the
control valve/cylinder.
– The oil return hose returns hydraulic oil from the control
valve/cylinder to the tank.
– Hose connections do NOT require thread seal tape.
Suction Hose
– This is the clear hose that connects the hydraulic tank to
the pump inlet.
– Secure both ends of hose with hose clamps.
Suction Hose
1. Using the provided hose clamps, connect one end of the clear
oil hose to the hydraulic oil tank (C) just beneath the beam
and the other end to the pump inlet on the side of the pump
(D). Securely tighten the clamps on both ends of the clear
hydraulic hose with either a flat head screw driver or 6mm
socket (Torque to 2.9-4.4 ft lbs.).
C
D
Oil Return (Low Pressure) Hose
2. Connect one end of hose to the control valve outlet (E).
Connect the other end of the hose to the oil filter inlet (F).
Securely tighten both ends of the hydraulic hose with a 27mm
wrench (Torque to 44 - 52 ft lbs.).
E
F