Full Product Manual

ManualsBrandsChampion Power Equipment ManualsOther9 Ton 80 cc Gas Wood Log Splitter with Auto Return and Storage Cover

100624 - 9 TON FULL BEAM LOG SPLITTER

MAINTENANCE

 WARNING

Never operate a damaged or defective log splitter.

 WARNING

Improper maintenance will void your warranty.



NOTICE

For Emission control devices and systems, read and

understand your resposibilities for service as stated in the

Emission Control Warranty Statement of this manual.

Make certain that the log splitter is kept clean and stored

properly. Only operate the unit on a ﬂat, level surface in a clean,

dry operating environment. DO NOT expose the unit to extreme

conditions, excessive dust, dirt, moisture or corrosive vapors.

Inspect all air vents and cooling slots to ensure that they are clean

and unobstructed.

Clean spark arrester every 100 hours.

Check and tighten all bolts and nuts before operating the log

splitter.

The owner/operator is responsible for all periodic maintenance.

Complete all scheduled maintenance in a timely manner.

Correct any issue before operating the log splitter.

For service or parts assistance, contact our

Technical Support Team at 1-877-338-0999.

Cleaning the Log Splitter

 CAUTION

DO NOT spray engine with water.

Water can contaminate the fuel system and can enter the

engine through the cooling slots and damage the engine.

Clear the debris from the beam, wedge and endplate.

Use a damp cloth to clean exterior surfaces of the engine and log

splitter.

Use a soft bristle brush to remove excess dirt and oil.

Use an air compressor (25 PSI) to clear dirt and small debris.

Wipe all metal parts with an oily rag to help prevent rust and

corrosion.

Changing the Engine Oil



NOTICE

Once oil has been added, a visual check should show oil

about 1-2 threads from running out of the ﬁll hole. If using the

dipstick to check oil level, DO NOT screw in the dipstick while

checking.

Change oil when the engine is warm. Refer to the oil speciﬁcation

to select the proper grade for your operating environment.

1. Remove the oil drain plug with a 12 mm socket

(not included) and extension.

2. Allow the oil to drain completely into an appropriate container.

3. Replace the oil drain plug.

4. Remove the oil ﬁll cap/dipstick to add oil.

MAX

MIN

OIL DIP STICK

5. Using a funnel, add up to 13.5 ﬂ. oz (0.4L) of oil (not included)

and replace oil ﬁll cap/dipstick. DO NOT OVERFILL.

6. Dispose of used oil at an approved waste management

facility.