Full Product Manual

25
100624 - 9 TON FULL BEAM LOG SPLITTER
MAINTENANCE
7. Reattach the clear suction hose to the pump. (A) Securely
tighten the clamp of the clear hydraulic hose with either a flat
head screw driver or 6mm socket
(Torque to 2.9-4.4 ft lbs.).
A
8. Using your fingers, open the hydraulic vent screw by turning it
counter clockwise approximately 2-3 times. (B)
B
9. Remove dipstick and add 115 fl. oz (3.4 L) of hydraulic oil -
ISO 32. Check the hydraulic oil level using dipstick. Oil level
should be between the two marks on the dipstick.
MAX
MIN
10. Start engine and purge air from hydraulic system.
Maintenance Schedule
Follow the service intervals indicated in the following maintenance
schedule.
Service your log splitter more frequently when operating in
adverse conditions.
Contact our Technical Support Team at 1-877-338-0999 to locate
the nearest CPE certified service dealer for your log splitter or
engine maintenance needs.
EVERY 8 HOURS OR DAILY
 Check engine and hydraulic oil levels
 Clean around air intake and muffler
FIRST 5 HOURS
 Change oil
EVERY 50 HOURS OR EVERY SEASON
 Clean air filter
 Change oil if operating under heavy load or in hot
environments
EVERY 100 HOURS OR EVERY SEASON
 Change oil
 Clean/adjust spark plug
 Check/adjust valve clearance*
 Clean spark arrestor
 Clean fuel tank and filter*
 Change hydraulic oil
 Change hydraulic oil filter (where applicable)
EVERY 250 HOURS
 Clean combustion chamber*
EVERY YEAR
 Inspect wheel bearings and repack bearing grease as
needed.
EVERY 3 YEARS
 Replace fuel line*
* To be performed by knowledgeable, experienced owners or CPE certified service
centers.