2700PSI GENERAC ? emss? l b Pro stion ur unit o Que king y tore, er h ta the s was ore Bef ack to ssure b pre e at 08 the elplin l l a -14 h c The Reliable Ones High Pressure Washer Owners Manual -270 CST 0 0 1-8 -F 8-5 M This pressure washer is equipped with an Automatic Cool Down System. See page 11 for details Model No. 10430 (2700 PSI High Pressure Washer) Manual No.
C A Generac 2700PSI High Pressure Washer R E N E G CAUTION: Always disconnect spark plug wire and place wire where it cannot contact spark plug to prevent accidental starting when setting up, transporting, adjusting or making repairs to your high pressure washer. The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation.
C A Generac 2700PSI High Pressure Washer R E N E G CONGRATULATIONS on your purchase of a GENERAC high pressure washer. It has been designed, engineered and manufactured to give you the best possible dependability and performance. Should you experience any problem you cannot easily remedy, please contact your nearest GENERAC Authorized Service facility, or call the 1-800 number listed on the front of this manual.
C A Generac 2700PSI High Pressure Washer R E N E G KNOW YOUR PRESSURE WASHER Read this owners manual and safety rules before operating your high pressure washer. Compare the illustrations with your high pressure washer to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference.
C A AS S E M B LY Generac 2700PSI High Pressure Washer R E N E G Read entire owners manual before you attempt to assemble or operate your new pressure washer. Your new pressure washer has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. PREPARING THE PRESSURE WASHER FOR USE If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the Pressure Washer Helpline at 1-800-270-1408.
C A AS S E M B LY Generac 2700PSI High Pressure Washer R E N E G Insert the carriage bolts form the outside through the holes on the handle and attach the plastic knobs on the inside. Tighten the knobs by hand (Figure 2). Although multi-viscosity oils (5W30, 10W30, etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible damage from running low on oil.
C A AS S E M B LY Generac 2700PSI High Pressure Washer R E N E G Attach other end of high pressure hose to the high pressure outlet on the pump (Figure 7). Tighten by hand. The manufacturer recommends fresh, clean unleaded automotive gasoline. Use clean fuel and store in approved, clean, covered containers. Use clean fill funnels. Never use stale gasoline left over from last season or gasoline stored for long periods. Clean area around fuel fill cap, remove cap. (Figure 5).
C A AS S E M B LY Generac 2700PSI High Pressure Washer R E N E G Attach dual lance to spray gun. Tighten by hand (Figure 9). CHECKLIST BEFORE STARTING ENGINE Figure 9 — Connect nozzle extension to spray gun. If you have reached this point, look back over the assembly to see if you have performed all of the following.
C A Generac 2700PSI High Pressure Washer R E N E G Apply the safety latch to the spray gun trigger (Figure 11). HOW TO USE YOUR PRESSURE WASHER Figure 11 — Safety Latch. If you have any problems operating your pressure washer, please call the pressure washer helpline at 1-800-270-1408. You have assembled your high pressure washer and have prepared the engine for starting. You are now ready to clean your car, boat, the outside of a building or whatever you plan to clean.
C A Generac 2700PSI High Pressure Washer R E N E G How to Use the Dual Lance and Adjust Pressure Applying Detergent IMPORTANT: Use soaps designed specifically for pressure washers. Household detergents could damage the pump. IMPORTANT: You must attach all hoses and turn on the water source fully before you start the engine. Starting the engine without all the hoses connected and without the water turned on will damage the pump.
C A Generac 2700PSI High Pressure Washer R E N E G Turn the chemical valve handle clockwise fully until it stops. This puts the gun into high pressure mode. Keep the spray gun a safe distance from the area you plan to spray. Apply a high pressure spray to a small area and then check the surface for damage. If no damage is found, you can assume it is okay to continue cleaning. Start at top of area to be rinsed, working down with same overlapping strokes as you used for cleaning.
C A Generac 2700PSI High Pressure Washer R E N E G GENERAL MAINTENANCE RECOMMENDATIONS Check Detergent Hose Examine the filter on the detergent hose and clean if clogged. Hose should fit tightly on barbed fitting. Examine hose for leaks or tears. Replace the filter or hose if either is damaged. The warranty of the high pressure washer does not cover items that have been subjected to operator abuse or negligence.
C A Generac 2700PSI High Pressure Washer R E N E G Remove additional debris by back flushing water supply through dual lance (Figure 15). Back flush between 30 to 60 seconds. Back flush both lances by turning chemical valve handle. Nozzle Maintenance If the nozzle on the dual lance becomes restricted or clogged with foreign materials, such as dirt, excessive pump pressure may develop. If this nozzle becomes partially clogged, it can cause a pulsing sensation during use.
C A Generac 2700PSI High Pressure Washer R E N E G 3.Place Run/Stop Switch in STOP position. 4.Empty the pump of all liquids by pulling recoil handle about 6 times. This should remove most of the liquid in the pump. NOTE: To protect unit from freezing temperatures, draw Antifreeze fluid into pump by pouring Antifreeze fluid into a 3-foot section of garden hose connected to inlet adapter and pulling recoil handle twice. 5.Store in a clean, dry area.
C A Generac 2700PSI High Pressure Washer R E N E G NOTES High Pressure Washer 15
C A Generac 2700PSI High Pressure Washer R E N E G TROUBLESHOOTING POINTS Problem Pump has following problems: failure to produce pressure, erratic pressure, chattering, loss of pressure, low water volume. Detergent fails to mix with spray. Cause Correction 1. Lance in low pressure mode. 2. Water inlet is blocked. 3. Inadequate water supply. 4. Garden hose is kinked or leaking. 5. Clogged inlet hose strainer. 6. Water supply is over 140°F. 7. Outlet hose is blocked or leaks. 8. Gun leaks. 9.
C A Generac 2700PSI High Pressure Washer R E N E G TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Engine will not start; or starts and runs rough. 1. 2. 3. 4. 5. 1. 2. 3. 4. 5. Engine shuts down during operation. Low oil level. Dirty air cleaner. Out of gasoline. Stale gasoline. Spark plug wire not connected to spark plug. 6. Bad spark plug. 7. Water in gasoline. 8. Excessively rich fuel mixture. 9. Intake valve stuck open or closed. 10. Engine has lost compression.
C A Generac 2700PSI High Pressure Washer R E N E G Drawing No.
C A Generac 2700PSI High Pressure Washer R E N E G Drawing No. B1988 REPAIR PARTS PRESSURE WASHER Item Part # Qty. Description Item Part # Qty. Description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 A1040B A1041 70453 97178 31669 B1210 99583 B1982 97054 B1288 B1232 21786 91682B 45771 22129 21217 74031 97100 97098 B2043 N/A 1 1 1 2 2 1 8 1 1 1 1 1 1 8 8 2 .
C A Generac 2700PSI High Pressure Washer R E N E G Drawing No.
C A Generac 2700PSI High Pressure Washer R E N E G Drawing No. B1317 REPAIR PARTS PUMP ITEM PART NO. DESCRIPTION 1 2 3 4 5 6 7 8 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 93871 96430A 96542 97215 95165 21277V 95441 93790 99427 96400 92479 93873 40945 97568A 93680 93668 93667 96015 99735 97027 96053 95504 95503 97128 97028 23707 QTY. GASKET, ENGINE ADAPTOR ADAPTOR, ENGINE BEARING, ROLLER THRUST POPPET, CHECK VALVE ADAPT., ENG.
C A Generac 2700PSI High Pressure Washer R E N E G NOTES High Pressure Washer 22
C A Generac 2700PSI High Pressure Washer R E N E G NOTES High Pressure Washer 23
C A Generac 2700PSI High Pressure Washer R E N E G LIMITED PRESSURE WASHER WARRANTIES (includes Master Contractor) GENERAC warrants to the original retail purchaser, the pressure washer manufactured by GENERAC to be free from defects in material and workmanship for the period(s) set forth below from the date of original purchase. This warranty is not transferable. The term original purchaser means the person for whom the pressure washer is originally purchased.
