Owner`s manual
Generac 2700PSI High Pressure Washer
GENERAC
11
High Pressure Washer
Allow the detergent to soak in for 3-5 minutes
before washing and rinsing.
For washing, start at lower portion of area to be
washed and work upward, using long, even, over-
lapping strokes.
CAUTION: Keep the plastic injector tube
from coming in contact with the hot muf-
fler. This will damage the plastic tube.
When inserting the filter into a cleaning
agent bottle, route the tube so as to keep it
from inadvertently contacting the hot muf-
fler.
Pressure Washer Rinsing
WARNING: Be extremely careful if you
must use the pressure washer from a
ladder, scaffolding or any other relatively
unstable location. Pressure in a running
washer builds as you climb. When you
press the trigger, the recoil from the initial
spray could force you to fall. The high pres-
sure spray could also force you to fall if you
are too close to the cleaning surface.
For Rinsing:
Remove the chemical injector hose from the chemi-
cal bottle to stop detergent from flowing. Spray until
the detergent has cleared form the gun.
Turn the chemical valve handle clockwise fully until
it stops. This puts the gun into high pressure mode.
Keep the spray gun a safe distance from the area
you plan to spray.
Apply a high pressure spray to a small area and
then check the surface for damage. If no damage
is found, you can assume it is okay to continue
cleaning.
Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for 3-5
minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach a tempera-
ture between 140145°F. When the water reaches
this temperature, the automatic cool down system
engages and cools the pump by discharging the
warm water onto the ground. This system prevents
internal damage to the pump.