Owner`s manual
14
High Pressure Washer
PREPARING THE UNIT FOR
STORAGE
Water should not remain in the unit for long periods of
time. Sediments of minerals can deposit on pump
parts and freeze pump action. If you do not plan to
use the pressure washer for more than 30 days,
follow this procedure:
1.Flush chemical injector hose by placing the injector
filter into a pail of clean water while running pres-
sure washer and squeezing the spray gun trigger
with the dual lance in low pressure mode. Flush for
two minutes.
2.Shut off the engine and let it cool, then remove all
hoses.
3.Place Run/Stop Switch in STOP position.
4.Empty the pump of all liquids by pulling recoil
handle about 6 times. This should remove most of
the liquid in the pump.
NOTE: To protect unit from freezing temperatures,
draw Antifreeze fluid into pump by pouring Antifreeze
fluid into a 3-foot section of garden hose connected to
inlet adapter and pulling recoil handle twice.
5.Store in a clean, dry area.
STORING THE ENGINE
See the engine Owners manual for instructions on
how to properly store the engine.
GENERAC
Generac 2700PSI High Pressure Washer