Installation Guide

102006 - AUTOMATIC TRANSFER SWITCH WITH aXis CONTROLLER™ MODULE
IMPORTANT SAFETY INSTRUCTIONS
4
IMPORTANT SAFETY INSTRUCTIONS
 WARNING
Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Instructions for Champion Automatic
Transfer Switch with aXis Controller
TM
Module
THE CHAMPION AUTOMATIC TRANSFER SWITCH WITH aXis
CONTROLLER
TM
MODULE IS NOT FOR “DO-IT-YOURSELF”
INSTALLATION. It must be installed by a qualified electrician
thoroughly familiar with all applicable electrical and building
codes.
This manual has been prepared for familiarizing servicing dealer/
installer with the design, application, installation and servicing of
the equipment.
Read the manual carefully and comply with all instructions.
This manual or a copy of this manual should remain with the
switch. Every effort has been taken to make sure that the contents
of this manual are accurate and current.
The manufacturer reserves the right to change, alter or otherwise
improve this literature and the product at any time without prior
notice and without any obligation or liability whatsoever.
The manufacturer cannot anticipate every possible circumstance
that might involve a hazard.
The warnings in this manual, tags and decals affixed to the unit
are, therefore, not all-inclusive. If using a procedure, work method
or operating technique the manufacturer does not specifically
recommend follow all codes to ensure safety for personnel.
Many accidents are caused by failing to follow simple and
fundamental rules, codes and precautions. Before installing,
operating or servicing this equipment, read the SAFETY RULES
carefully.
The publications that cover the safe use of ATS and installation
are the following NFPA 70, NFPA 70E, UL 1008 and UL 67. It is
important to refer to the latest version of any standard/code to
ensure correct and current information. All installations must
comply with local municipal, state and national codes.
Before Installation
 WARNING
Per OSHA 3120 Publication; “lockout/tagout” refers to
specific practices and procedures to safeguard individuals
from the unexpected energization or startup of machinery
and equipment, or the release of hazardous energy during
installation, service or maintenance activities.
 WARNING
Be certain that the power from the utility is turned off and all
backup sources are locked out before starting this procedure.
Failure to do so could result in serious injury or death. Be
aware, automatic start generators will start upon loss of utility
mains power unless locked in the “off” position.
Consult the generator operator manual section to locate the
ATS CONTROL and ENGINE CONTROL modules to make sure
both switches are in the OFF position.
 CAUTION
Consult with your Local municipal, State and National
electrical codes for proper mandatory wiring methods.