User`s manual

INSTALLATION INSTRUCTIONS

Before Using Your Refrigerator

 Remove the exterior and interior packing.

 Before connecting the refrigerator to the power source, let it stand upright for

approximately 4 hours. This will reduce the possibility of a malfunction in the

cooling system from improper handling during transportation.

 Clean the interior surface with lukewarm water using a soft cloth.

 Take off all plastic protection cover around the cabinet for better heat exchange on

the surface.

Installing Your Refrigerator

 This appliance is designed to be free standing only, and should not be recessed or

built-in.

 Place your refrigerator on a floor that is strong enough to support the refrigerator

when it is fully loaded.

 Allow 5 inches of space between the back and sides of the refrigerator, which

allows the proper air ventilation. Adjust the feet to keep the refrigerator level.

 Locate the refrigerator away from direct sunlight and sources of heat (stove,

heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat

sources may increase electrical consumption. Ambient temperature below 50°F or

above 85°F will hinder the performance of this appliance. This unit is not

designed for use in a garage or any other outside installation.

 Avoid locating the refrigerator in moist areas.

 Plug the refrigerator into dedicated, properly installed-grounded wall outlet. Do not

under any circumstances cut or remove the third (ground) prong from the power

cord. Any questions concerning power and/or grounding should be directed toward

a certified electrician or an authorized service center. This unit is not designed

to be installed in a caravan or used with an inverter.

 After plugging the appliance into a wall outlet, turn the unit on and allow the

unit to cool down for 2~3 hours before placing food in the refrigerator or

freezer compartment.