Product guide

4
3
Place lower back panel between side panels at rear of bottom shelf. Make sure the slots are positioned as shown (A). Secure
lower back panel to side panels using two 1/4-20x1/2" screws, 7mm lock washers and 7mm flat washers on each side.
Attach upper rail to cart assembly. Tabs on rail fit inside legs. Secure rail to back of front legs using two ST4.2x10mm self-tap
screws on each side.
Upper rail
ST4.2x10mm
self-tap
screw
Rear view
Lower back panel
7mm flat
washer
7mm lock
washer
1/4-20x1/2”
screw
This step requires two people to lift and position
grill head onto cart. Carefully lower the grill head onto
the cart between the two braces, inserting tabs in sides of
firebox into cut-outs in rear legs. Make sure the regulator
hose is hanging outside the cart. Insert 1/4-20x2” screw
through each rear leg (3rd hole from top) and through grill
head. Secure with 7mm flat washers, 7mm lock washers
and 1/4-20 hex nuts. Do not fully tighten.
Rear view
1/4-20x2”
screw
7mm flat
washer
7mm lock
washer
1/4-20
hex nut
Tabs on firebox into
leg cut-outs.
463260307 • 15