Owner Manual

98
pressed the minute portion should no longer blink indicating
that it is set.
• After pressing the Time Button in the previous step the time
should begin to count down.
• When using the Time function, the display should show
the Set Cooking Temperature and the actual elapsed Time
(countdown). They should alternate throughout the length of
the cooking cycle.
• Once the desired set time has elapsed:
1. The controller will automatically reduce the appliance
temperature to 120°F (49°C).
2. The display will alternate between 00:00 and 120°F (49°C)
showing the set time has elapsed.
3. An audible beep will sound 3 beeps and then 3 beeps once
every 30 seconds thereafter until the Power Button is
pressed, or has reached the maximum 19 hour automatic
shut-o.
Cooking With The Meat Probe
When cooking with the meat probe function, your smoker will run
until the meat hits a desired internal temperature.
Good Meat Probe Etiquette:
• Insert the probe into the thickest part of the food - not touching
bone, fat or gristle before placing meat in the smoker. Once
the meat is in place you can connect the meat probe jack to the
smoker.
• After cooking, check the temperature in several places to make
sure the food is evenly heated.
• Make sure to clean your food thermometer with hot, soapy,
water before and after each use. Do not immerse or wash in the
dishwasher.
• Compare your thermometer reading to the USDA guidelines
on page 13 to determine if your food has reached a safe
Using the Temp Button
Display Range: 100°F - 275°F (38°C - 135°C)
• Press the Temp Button. The default temperature setting of
200°F (93°C) is shown.
• Press and hold the “UP” or “DOWN“ button to adjust the
desired cooking temperature.
• Press the Temp Button again after the desired temperature
setting is entered. After the Temp Button is pressed the display
should no longer blink, indicating that cook temperature is set.
Cooking With The Timer
When cooking with timer function, your smoker will run until the
timer hits zero.
Here’s how to set it up:
Display Range: 00:00 – 19:00 hours.
NOTE: The Meat Probe function will be disabled.
• Press the Time Button, and a blinking “00:00” is shown.
• Press the “UP” or “DOWN“ button to adjust the hour in 1 hour
increments. (The display should still be blinking.)
• Press the Time Button again after the desired hour portion
of the cook time setting is entered. After the Time Button is
pressed, the hour portion should no longer blink indicating that
it is set.
• The minute portion will remain blinking at this point as it has
not yet been set.
• Press the “UP” or “DOWN“ button to adjust the minutes.
The display should still be blinking.
• Press the Time Button again after the desired minute portion
of the cook time setting is entered. After the Time Button is
15.122905 2015 Grilling Guide.indd 8-9 6/1/15 11:12 AM