Operating Guide

OM5050F.3 ™ & © Char-Griller / A&J Mfg. 10

Step 1: Assemble the Leg Cross Bar, Short Leg, Long Leg, and Leg Braces then secure them

with four 2 1/4” Hex Bolts, four Flat Washers, four Lock Washers, and four Hex Nuts. Orient the

Leg so that the holes on the Legs and Leg Cross Bar are pointing in the direction of the Leg

Braces Side, see Below. NOTE: The orientation of the Legs are critical for later steps so pay

careful attention to how they go together.

Leg Brace

Hex Bolts

Leg Cross Bar

Short Leg

Long Leg

Hex Nuts

Flat Washers

Lock Washers

Hex Bolts

Step 2: Lay down the assembly on the floor with the Leg Braces pointing up then install the

other set of Leg Cross Bar, Short Leg, Long Leg, and Wire Shelf using four 2 1/4” Hex Bolts,

four Flat Washers, four Lock Washers, and four Hex Nuts. First insert the Wire Shelf extend

bars at the end of the Wire Shelf into the upper hole on the Long Legs then insert a bolt

through the Leg Brace, Long Leg, Flat Washer, Lock Washer, and loosely tighten with a Hex Nut.

Then Place the other Leg Cross Bar, Short Leg in place (making sure that the holes on the Leg

Cross Bar and Short Leg are pointing in the direction of the Leg Brace) and secure them with

Hex Bolts and Hex Nuts. NOTE: The orientation of the legs are critical for later steps so pay

careful attention to how they go together.

Leg Cap

Leg Cross Bars

Short Leg

Long Leg

Wire Shelf

Hex Bolt

Hex Nuts

Flat Washer Lock Washer