How to Guide
87
sively work the
cement into the
surface.
t 8JUIPVU SFEJQ-
ping the applica-
tor in the cement,
apply a thin layer
of cement to the
fitting socket ag-
gressively work-
ing it into the
surface.
INSTALLATION PROCEDURES
3. Clean and Dry
Pipe and
Fittings
t 3FNPWF TVSGBDF
dirt, grease or
moisture with a
clean dry cloth.
3
4
5
t %POPUBMMPXDFNFOUUPQVEEMFPSBDDVNVMBUFJOTJEFUIF
system.
t 4PMWFOU DFNFOU TIPVME DPOGPSN UP "45. ' BT
shown in the accompanying table. All purpose cement
is not recommended.
t 1SJNFSJTOPUSFRVJSFEGPS'MPX(VBSE(PME
®
one-step ce-
ment, but may be used. Check local code requirements.
6
4. Dry Fit
t 8JUI MJHIU QSFT-
sure, pipe should
go one half to one
third of the way
into the fitting
hub. Pipe and
fittings that are
too tight or too
loose should not
be used.
5. Applicator
t 6TFBOBQQMJDBUPS
that is one half
UIF TJ[F PG UIF
QJQFTEJBNFUFS
t 5PP MBSHF BO BQ-
plicator will force
excess primer or
cement into the
inside of the fit-
ting. Too small
an applicator will
7
7. Join Pipe and
Fittings
t "TTFNCMF QJQF
and fittings quick-
ly while cement is
fluid. If cement
has hardened, cut
pipe, dispose of
fitting and start
over.
t *OTFSUQJQFJOUPmUUJOHIVCHJWJOHBRVBSUFSUVSOFOTVS-
ing an even distribution of cement within the joint.
t 0ODFUIFQJQFDPOUBDUTUIFTPDLFUCPUUPNIPMEQJQFBOE
fitting together until the pipe does not back out.
t "MJHO BMM QJQJOH TZTUFN DPNQPOFOUT QSPQFSMZ XJUIPVU
strain. Do not bend or pull pipe into position after being
solvent welded.
2
2. Remove Burrs
and Bevel
t 3FNPWF BMM QJQF
burrs from inside
and outside diam-
eter of pipe with a
knife edge, file or
de-burring tool.
t $IBNGFS CFWFM
the end of the
pipe 10° - 15°.
6. Coat Surface with
Cement
t 4UJSPSTIBLFUIFDF-
ment prior to use.
t "QQMZ B GVMM FWFO
layer of cement to
the pipe surface to a
QPJOUÜwCFZPOEUIF
hub depth. Aggres-
not apply sufficient cement.