Replacement Part List

SAFETY DATA SHEET
PVC Pipe and Fittings
Date Updated: 10/05/2020
Page 5 of 9
This document has been classified as Public
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
INGREDIENT
CAS
NUMBER
%
WEIGHT
PEL-OSHA
TLV-ACGIH
NIOSH REL
Polyvinyl chloride
9002-86-2
> 80%
None established
Particulates not
otherwise classified:
15 mg/m
3
1 mg/m
3
(respirable
fraction)
Particulates not
otherwise classified:
10 mg/m
3
(inhalable
fraction)
None established
Titanium dioxide
13463-67-7
0-5%
15 mg/m
3
, total dust
10 mg/m
3
TWA
None established
ENGINEERING CONTROLS: If user operations generate dust, fumes, gas, vapor or mist, use process enclosures, local
exhaust ventilation, or other engineering controls to keep worker exposure to airborne contaminants below recommended
and statutory limits.
RESPIRATORY PROTECTION: Cutting or sanding this product can generate dust. Used a properly fitted particulate filter
respirator complying with an approved standard if a risk assessment indicates this is necessary. Respirator selection must
be based on known or anticipated exposure levels, the hazards of the product, and the safe working limits of the
respirator. A NIOSH-approved N95 single use or P95 multiple use respirator will protect the employee from at least 95%
of airborne particles. Follow the respirator manufacturer’s instructions for proper use. If adhesives or other substances are
used with this product, refer to the product manufacturer’s safety data sheet for applicable respiratory protective
measures.
SKIN PROTECTION: Chemical-resistant, impervious gloves complying with an approved standard should be worn when
handling this or any chemical product, if a risk assessment indicates this is necessary. Considering the parameters specified
by the glove manufacturer, check during use that the gloves are still retaining their protective properties. It should be noted that
the time to breakthrough for any glove material may be different for different glove manufacturers. In the case of mixtures
containing several substances, the protection time of the gloves cannot be accurately estimated. If adhesives or other
substances are used with this product, refer to the product manufacturer’s safety data sheet for applicable skin protective
measures.
BODY PROTECTION: Personal protective equipment for the body should be selected on the task being performed and the
risks involved, and should be approved by a specialist before handling this product. If adhesives or other substances are
used with this product, refer to the product manufacturer’s safety data sheet for applicable skin protective measures.
EYE/FACE PROTECTION: Safety eyewear complying with an approved standard must be used when a risk assessment
indicates this is necessary to avoid exposure to dust. Particulates and dust can be formed when cutting, grinding or
sanding this product. If contact with dust or particulates is possible, the following should be worn unless the assessment
indicates a higher degree of protection: safety glasses with side shields. If adhesives or other substances are used with
this product refer to the product manufacturer’s safety data sheet for applicable eye and face protective measures.