Installation Guide

page 5
5. Fan Assembly (with downrod). (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging
ball rest on the hanging bracket. Turn the hanging ball
slot until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball
with tab in hanging bracket may result in serious injury
or death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It will
be necessary to use a heavy duty wood screw, washer
and lock washer (not supplied) with the safety cable
loop. If necessary, adjust the loop at the end of the
safety cable. The loop at the end of the safety cable
should just fit over the threads on the wood screw.
Test safety cable by pulling on loose end of cable with
pliers. If the safety cable slips, the cable must be pulled
tighter. Extra cable slack can be left in ceiling area.
6. Fan Assembly (flushmount).
Remove and set aside canopy cover to reveal
6 holes. Notice that 3 of these holes are larger.
NOTE: Yoke cover is not used with this type of
installation.
If there are only 3 screws in top of motor housing,
please proceed to next paragraph. If there are
6 screws in top of motor housing, remove every
other screw and lock washer.
Thread wiring through canopy ring and canopy.
Place canopy over yoke, aligning larger holes in
canopy with the 3 existing screws in top of motor
housing. Insert the 3 screws and 3 lock washers
that had been removed (if there were only 3
screws located in top of motor housing, these
screws/lock washers will be located in one of the
hardware packs) into the remaining holes.
Securely tighten these screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over the
hanging bracket tab. (Use one of the non-slotted
holes on the rim of the canopy to do so.)
canopy
canopy cover
canopy
motor
housing
yoke
canopy
ring
set screw
wood ceiling
joist
hanging ball slot
motor housing
safety cable
hanging bracket tab
wood screw
and washer
safety cable
loop
canopy
motor housing
hanging bracket tab