Installation Guide

page 8
10. Light Kit Assembly. (cont.)
Remove finial, finial plate, hex nut, flat washer
and rubber washer from threaded rod on light
kit fitter.
Raise glass shade in order to guide pull chains
through corresponding holes in glass shade.
Align threaded rod on light kit fitter with hole
in middle of glass shade and push up gently,
allowing threaded rod to come through hole.
Replace rubber washer and flat washer on
threaded rod and secure glass shade with hex
nut that was previously removed.
DO NOT
OVERTIGHTEN
hex nut as glass may crack or break.
Thread pull chains through corresponding
holes in finial plate, allowing threaded rod to
come through hole in middle of finial plate, and
push up. Thread center pull chain through hole
in finial and re-attach finial. DO NOT OVERTIGHTEN
finial as glass may crack or break.
threaded rod
light kit fitter
motor
housing
glass
shade
switch housing
finial
finial plate
flat washer
hex nut
rubber washer
fan pull chain
light pull chain
diagram 2 diagram 3 diagram 4
diagram 1
11. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain on the switch housing. Start at the OFF
position (no blade movement). First pull will set the
fan to HI. Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull will
again set the fan to the OFF setting. If applicable, test
light with the pull chain in the middle. (diagram 1) If
fan and/or light do (does) not function, please refer
to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse
switch (located on the switch housing). Set reverse
switch to recirculate air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extensions supplied or custom
pull chain extensions (sold separately) to ends of
the pull chains
reverse
switch
switch
housing
pull chain
extensions